Total load capacity for both outlets must not exceed 600W (5A) incandescent, 1800W (15A) resistive or 1/2HP motor. Specifications subject to change without notice due to continuing product improvement Getting to know your new Z-Wave device Operating temperature range: 32-104° F (0-40° C) line of sight between the wireless controller and the closest Z-Wave receiver module Total maximum load for both Z-Wave controlled outlets: 600W (5A) tungsten, 1/2HP motor or 1800W (15A) resistive Please contact our U.S.-based Consumer Care at 1-80 (option 1) between 7AM – 8PM, M-F, Central Time or if the unit should prove defective within the warranty period. This warranty gives you specific rights, and you may also have other rights which vary from state to state. Some states do not allow limitations on how long an implied warranty lasts or permit the exclusion or limitation of incidental or consequential damage, so the above limitations may not apply to you. This warranty is in lieu of all other warranties, expressed or implied. This warranty is limited to the repair or replacement of this product only and does not extend to consequential or incidental damage to other products that may be used with this product.
Enbrighten smart switch free#
Jasco Products Company warrants this product to be free from manufacturing defects for five years from the original date of consumer purchase.
Enbrighten smart switch install#
IF THE PLUG DOES NOT FIT INTO THE OUTLET, CONTACT A QUALIFIED ELECTRICIAN TO INSTALL THE PROPER OUTLET.
THIS PLUG WILL ONLY FIT INTO A GROUNDING POWER OUTLET. TO REDUCE THE RISK OF ELECTRIC SHOCK, THIS PRODUCT HAS A GROUNDING PLUG THAT HAS A THIRD (GROUNDING) PIN. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device. Important note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted.
Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Such modifications could void the user’s authority to operate the equipment.
Enbrighten smart switch tv#
FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.